LEGO stand for Newton 2×00

Because Apple never design any stand for Newton, I decided to design and build my own. And because I love LEGO Technic, I decided to use LEGO for this.

Here is a couple photos of my stand for Newton 2000 and Newton 2100. My stand have holder for pen, adjustable tilt angle and power cable holder 🙂

Farallon Ethernet PC Card for Newton

Some time ago I bought on eBay network card for Newton. Farallon Ethernet PC Card (EtherWave and EtherMac – PN895). I always thought that Farallon card are the best for Newton. But this card surprised me a lot. I just can’t setup and run it!

Newton recognise this card, but card can’t get proper connection. I did couple tests on different Newton units to check if drivers working correctly (sometimes NewtonOS can have problems, especially if you want to use many different drivers for a lot of LAN/WiFi cards).

So, at this point I’m not sure where is the problem, because there is only one driver for NewtonOS and Newton recognise this card properly. What if funny, I have similar problem with old 3Com Etherlink III (3C589D) card. I’m not sure why I can’t run it properly. And Newton don’t show info window for this 3Com card.

Weird. I must do the research…

PIXsolution Implant-2000 – accelerator board for Newton 2×00

I just discovered that i have Newton 2000 with upgrade to 2100 and with some module, which speed up Newton. I didn’t knew about it before, because Newton has never been run before by me.

At the beginning I thought that Newton is broken, because I couldn’t get connection with computer to backup data. That was weird. The second thing was different startup sound – the pitch was too high. So, I decided to open Newton and check it. And bingo! There is some module inside!

I asked Newton community to help me recognise this module. More info later…

UPDATE

And after couple minutes my friend Jake Bordens (constructor of the internal WiFi module for Newton) send me name of this module. It is Implant-2000, accelerator board for Newton 2×00, produced by the PIXsolution company in 1998 year. Couple info about this module (archive website):

  • CPU speed control based on Implant-2000 technology
  • sleep mode to save battery power
  • switch control to deactivate Implant-2000 module on the fly
  • Implant-2000 performance factor about 40%-60%
  • realtime clock NOT accelerated (full compatible)
  • maximum quiescont supply current 3.3 Volt 200uA
  • maximum quiescont supply current in sleep mode 100uA
  • Implant-2000 based on 3.3V CMOS technology
  • fixed CPU speed factor over 220MHz
  • Size: length 29 mm; width 25 mm; height 4 mm

What is interesting, this module allow to switch between original and ‘new’ speed. Thanks to this, Newton don’t have problems when I want to connect to computer or run sensitive programs.

This module is very small, so (as you see on photo) can be installed inside Newton. The only one think I don’t like is the quality of installation of this module. Someone just used sticker tape. It does not look professional. I will try fix it in future.